BHudson
BHudson
Group: Moderator
Joined: 23rd December 2013 3:33 pm
Title: USA Robox Support Moderator
@stevepf During normal use, turning the printer off with the...

In forum Materials

1 week ago
@stevepf A couple of points for future reference: 1. Always ...

In forum Materials

1 week ago
@alex4855 This isn't new - the files have always been listed...

In forum Questions and Answers

1 week ago
@olivier-masson This is an indication that the print head ha...

In forum Technical Support

2 weeks ago
My solution to wet filament is a set of airtight plastic bin...

In forum Questions and Answers

2 weeks ago
@doncolley Yes the DualMaterial head is fully supported in A...

In forum Software

2 weeks ago
@cgoldspink Your origin in good SW practice should be within...

In forum AutoMaker beta testing

3 weeks ago
This error usually means there is a filament feed error duri...

In forum Questions and Answers

3 weeks ago
We are working on it, but it will take some time. There will...

In forum Questions and Answers

3 weeks ago
@adikuor Do you mean the extruder, the part that drives the ...

In forum Questions and Answers

3 weeks ago
@cgoldspink No, I was not able to replicate the behavior wit...

In forum AutoMaker beta testing

3 weeks ago
I prefer PolyMaker PolySupport for nylon. I have seen severa...

In forum Materials

3 weeks ago
@cgoldspink No, I haven't seen that. Please try a clean inst...

In forum AutoMaker beta testing

3 weeks ago
@jellison Try a different USB port and try a different PC. I...

In forum Technical Support

4 weeks ago
@evilsteve I have several spring steel plates laser cut to t...

In forum Materials

4 weeks ago
Page 1 / 197
Share:
This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.
For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software. This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.