Pete
Pete
Group: Admin
Joined: 11th October 2013
Title: I am Pete Admin
AutoMaker 4.00.02_RC5 beta test

In forum AutoMaker beta testing

10 hours ago
You are correct Steve, it should be easier to spot this in t...

In forum Materials

2 days ago
wow, looks great. it would be good to have some scaling info...

In forum Show us your bits!

1 week ago
@stevepf It should be in your default profiles as PA12 &nb...

In forum Materials

1 week ago
@rojikku It is possible that the material was not mixed as i...

In forum Materials

1 month ago
Welcome to the Robox forum. Often a gear generator can be us...

In forum Show us your bits!

2 months ago
Be sure to flex the cables while testing the circuit, the fu...

In forum Chatter

2 months ago
@jbains sorry for the lack of reply I must have missed this ...

In forum Technical Support

2 months ago
Thanks for the update, I will edit your earlier posts to poi...

In forum Technical Support

2 months ago
@dounebank ok great. We write the IMG to the card using a pr...

In forum Software

2 months ago
@dounebank I poked it a bit, please check the link again.

In forum Software

2 months ago
@dounebank take a look here, you should have access now, let...

In forum Software

2 months ago
Thanks, we had a great time with it.

In forum Show us your bits!

2 months ago
@dounebank i've moved your post to the software area. Becaus...

In forum Software

2 months ago
@irving moved to materials forum.

In forum Materials

2 months ago
Page 1 / 176
Share:

This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.

For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.