Notifications

Firmware r769 error  

  RSS
82_András
(@nagyandrass)
Eminent Member Customer

Hi,

The automaker incorrectly indicates the ambient temperature after the M500 g code. (firmware r769)
When is an update expected to fix this issue?
(I put back the r768 version, it correctly shows the temperature in Automaker 4.0.0.2)

This topic was modified 1 month ago by 82_András
Quote
Posted : 19th January 2020 5:02 pm
Pete
 Pete
(@pete)
I am Pete Admin

@nagyandrass there is a fix for this in the new software.

You are welcome to test it. I just posted this https://www.cel-uk.com/community/am-beta/beta-test-automaker-4-01-00/

For official support please create a support ticket using this link www.cel-robox.com/support/

ReplyQuote
Posted : 20th January 2020 10:27 am
82_András
(@nagyandrass)
Eminent Member Customer

@pete

Is it possible to install 4.01.00 so that version 4.0.0.2 remains functional? Or overwriting 4.0.0.2?

 

ReplyQuote
Posted : 20th January 2020 11:54 am
Pete
 Pete
(@pete)
I am Pete Admin

You can install in a different directory but the folders in /Documents/CEL Robox/ will still be used.

To avoid any contamination of your profiles etc while using the beta version (which wont update automatically) you can rename that /Documents/CEL Robox/ folder before installation of a different version. It gets created automatically if needed on software restart.

For official support please create a support ticket using this link www.cel-robox.com/support/

ReplyQuote
Posted : 20th January 2020 1:32 pm
82_András
(@nagyandrass)
Eminent Member Customer

@pete

Thanx ;)

ReplyQuote
Posted : 20th January 2020 1:58 pm
Share:

This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.

For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.
Images and content placed on this forum may be used by CEL and in related media without reward or attribution.