Filament Brittle an...
 

Filament Brittle and Breaking  

  RSS
Rose Smith
(@rojikku)
New Member

I just bought a new reel of TitanX and the filament keeps breaking. Like at least every 2 hours. Bad reel I’m assuming? And recourse or ideas on recovering it?

Quote
Posted : 15th August 2019 10:52 am
Pete
 Pete
(@pete)
I am Pete Admin

@rojikku It is possible that the material was not mixed as it was created. Please post the colour here and if there is a batch code sticker on the bag please post that information as well.

Batch sticker example below

For official support please create a support ticket using this link www.cel-robox.com/support/

ReplyQuote
Posted : 19th August 2019 9:36 am
Share:

This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.

For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.