Material resistant ...
 

Material resistant to fire  

  RSS
olivier
(@olivier-masson)
Eminent Member Customer

Hi

Does anybody use a material which has properties for fire ? Like resistance V0 (do not propagate the fire).

Any material better than those which take and increase fire are welcome.

Thank you in advance.

 

Olivier

 

Quote
Posted : 13/05/2019 5:10 pm
Pete
 Pete
(@pete)
I am Pete Admin

@17bt had a go with a reel I sent him.

For official support please create a support ticket using this link www.cel-robox.com/support/

ReplyQuote
Posted : 14/05/2019 3:47 pm
Mike
 Mike
(@17bt)
Prominent Member

I did some time ago, never tested it with fire though. 

This stuff is though

https://www.filoalfa3d.com/en/specialties-oversize/177-abs-v0-black-o-175-mm-flame-resistant-8050327032026.html

ReplyQuote
Posted : 14/05/2019 5:10 pm
Mike
 Mike
(@17bt)
Prominent Member

@olivier-masson I was looking at another high temperature material, and I saw this from FormFutura, a V0 ABS

https://www.3djake.uk/formfutura?&f%5B69%5D=577

Hope this is of use, and they also sell it in the Netherlands cheaper, so presumably it will be where you are.

https://www.formfutura.com/shop/category/abs-absprotm-flame-retardant-165

Mike

This post was modified 3 months ago by Mike
ReplyQuote
Posted : 02/06/2019 10:51 pm
Share:

This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.

For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.