AutoMaker update fails  

  RSS
Hoop2125
(@michael-4817)
Active Member Customer

Today I was notified by AutoMake there was an update. When I click it, it opens up the update window, downloads the update, someplace?? and then quits. Mac 10.4.14 Automaker 4.00.00

Quote
Posted : 22nd May 2019 12:35 am
Pete
 Pete
(@pete)
I am Pete Admin

Looking into this. To manually update please use the links on this page https://www.cel-uk.com/shop/automaker/

This post was modified 4 weeks ago by Pete

For official support please create a support ticket using this link www.cel-robox.com/support/

ReplyQuote
Posted : 22nd May 2019 9:06 am
littlejo
(@littlejo)
New Member

I have had the same issue as Hoop2125. I tried to download the update from the link given but was given the message that it could not be opened as the application may be damaged or incomplete. Automaker-4.00.01-osx-installer

ReplyQuote
Posted : 22nd May 2019 3:47 pm
George
(@george)
Member Admin

We have tested it here and it seems if you try and run the installer again it should work on the second attempt... could you try that and let us know how it goes? We are working on a fix for the Mac update issue

ReplyQuote
Posted : 23rd May 2019 10:09 am
Hoop2125
(@michael-4817)
Active Member Customer

Nope, did not work even when I ran it 4 times

ReplyQuote
Posted : 25th May 2019 4:10 am
Share:
This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.
For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software. This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.