Build Volume  

   RSS

0

Does anyone know what the real Build Volume is for the Robox Cube? I certainly isn't what what is stated in the printers manual. By Build Volume I take it to mean the maximum envelope in which a model can be printed in the printer.

thanks

Dazza000

What is the Robox Cube? Do you mean the RoboxPro? The Pro build dimensions are 210 X 300 x 400 mm. I do not see anything that would reduce this build volume.

The RBX01 and RBX02 have the same build dimensions: 150 x 210 x 100 mm, though there are a few restrictions on this. In dual material mode, the Y dimension is reduced slightly to account for the second Bowden tube and extruder and at the very top of the build volume the X dimension is reduced slightly on the right side.

2 Answers
1

Thanks for Replying Ben,

I have the basic RBX01 and I have discovered that the maximum z height is only 80mm not the stated 100mm. Can you tell me exactly what the maximum dimensions realy are so that I and everybody else dont waste our time trying to design models that won't fit!

thanks

The maximum height of the Robox RBX01 and RBX02 is a full 100 mm. I have tested this many, many times - every printer that I repair has to print to its full height before it ships. 

It sounds like you have a problem with your printer. If you will open a support ticket and describe in detail what your issue is we can assist you to determine what the problem is and how to fix it. 

0

This post was modified 10 months ago by Pete

For official support please create a support ticket using this link www.cel-robox.com/support/

Share:

This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.

For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.