Recent Posts
 

Recent Posts
Forums  |  Topics  |     

 Topic TitleForum
jbains Heated bed not working  

By jbains 16 hours ago  |  Last Post: 16 hours ago

Technical Support
 
Dounebank Automaker 4.00.01 & Root Error print queue transfer of the print job failed  

By Dounebank 3 days ago  |  Last Post: 1 day ago

Questions and Answers
 
Pete Robox team entered the Portishead Soapbox race  

By Pete 6 days ago  |  Last Post: 3 days ago

Show us your bits!
 
Irving PVA Filaments  

By Irving 4 days ago  |  Last Post: 4 days ago

Materials
 
Falcom robox heats up the power up  

By Falcom 5 days ago  |  Last Post: 5 days ago

Questions and Answers
 
Volker Knobe Filament loaded but Automaker say no filament load  

By Volker Knobe 1 week ago  |  Last Post: 1 week ago

Technical Support
 
Pete Robox units originating from or purchased directly from box.co.uk or ebay seller box_uk  

By Pete 2 weeks ago  |  Last Post: 2 weeks ago

Technical Support
 

 

 

 

Share:

This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.

For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.