Anyone tried the new Pathio slicer?
It's been a coon's age since have been here. I have two Robox's but am engaged with a major software project demands most of my time. So, my 3D printers have been gathering dust. So, maybe this is an old topic but notrhing comes up when I serachfor Pathio here.
Pathiois doing some interesting things with slicing that they say results in stronger, smoother, better prints. They don't have a saved profile for Robox but say their stuff is compatible with any G-Code machine.
In a week I have open heart surgery so it will probably be several weeks before I resurface.
@heartlander I saw this a while back, but it's a lot better now. Just having a play, and looking at the GCode. The Scripts section is very comprehensive, as is the syntax variables you can create, like "state/next_toolhead" etc and there's conditionals thrown in to. No comms yet with Robox, but not ready for that, just looking at how the gcode is parsing.
Good luck with the op, my Uncle Sam had it, never felt better after the first few weeks, and still breathing years later. :)
This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.
For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.