Automaker upgrade  

  RSS
Don Colley
(@doncolley)
Estimable Member

Does Automaker 4.000.00 support Roboxdual because it does all kinds of weird tricks on my machine?

Quote
Posted : 11/05/2019 5:12 pm
BHudson
(@bhudson)
USA Robox Support Moderator

@doncolley Yes the DualMaterial head is fully supported in AM 4.00.00. Are you using the Pro version? If not, you may find that you need to change the material assignment from material 1 to material 2 and back again. This has been reported a couple of times. If you can provide some actual details of the behavior you are seeing it will help with troubleshooting.

ReplyQuote
Posted : 12/05/2019 6:41 pm
Don Colley
(@doncolley)
Estimable Member

(@bhudson)

I re loaded ver 4 and this time it appears to be working ok, thanks for your reply.

 

ReplyQuote
Posted : 14/05/2019 12:00 pm
Share:

This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.

For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.