Using the large noz...
 

Using the large nozzle  

  RSS
Iulian
(@nemo107)
New Member

Seems this thread went off topic so I'll try to see if I undestand.

I have the first kickstarter robox and I had never seen it print with the large nozzle. Did I correctly understand that this is due to CURA and that slic3er has errors? In the latest version of Automaker there is no option except CURA2 (for $). Does CURA2 support the large nozzle? or the whole dual nozzle selling point is pointless at this moment?

Quote
Posted : 1st December 2019 10:44 am
Pete
 Pete
(@pete)
I am Pete Admin

@nemo107 I split this out of the previous thread to keep it tidy.

The large nozzle on the QuickFill head can be used in all AutoMaker versions.

It is used by default in the Draft profile on the current AutoMaker 4.00.02 for Infill and for Perimeters. The Support, Rafts and first layer use the smaller 0.3mm nozzle.

You can edit your profile to use either nozzle for various different parts of a build by changing the settings. To edit the settings remember to save the profile with a new name first.

For official support please create a support ticket using this link www.cel-robox.com/support/

ReplyQuote
Posted : 2nd December 2019 11:29 am
Iulian liked
Share:

This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.

For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.
Images and content placed on this forum may be used by CEL and in related media without reward or attribution.