Heated bed not working  

  RSS
jbains
(@jbains)
New Member

Hi,

 

I am new to the forum.

 

I hope someone can help, I have a Robox with a single extruder that will not print due to the heated bed not heating up to the target temperature. I have had a look around the forum and a google search for help.

All I have been able to find is this post: https://www.cel-uk.com/community/technical-support/bed-will-not-heat/

I have sent G-code: M105. Output: S:35 @0 T:-22 @0 B:27 ^0 A:29*0

Responce from M999: Bdelta:0.0

ok

I have also noticed from the diagnostic screen that the y axis limit switch seems to be constantly lit.

Can anyone help me get the printer working?

Thanks

 

 

 

 

Quote
Posted : 21st July 2019 1:11 pm
Pete
 Pete
(@pete)
I am Pete Admin

@jbains sorry for the lack of reply I must have missed this one.

Your M105 report B:27  indicates that the ambient temperature is being read by the thermistor in the bed and ^0 no heating is being attempted.

https://robox.freshdesk.com/support/solutions/articles/1000138396 (you might need to log in to the support portal to view the content)

Y axis limit switch is shown on this page https://robox.freshdesk.com/support/solutions/articles/1000133457-home-x-y-or-z-without-homing-other-axes-

It is quite delicate when the case is opened, it might have been damaged by someone.

In all cases please create a support ticket for official advice, if you intend to open the casing you must unplug all connections to the printer including USB and allow it to rest for at least 30 mins before working on it to allow capacitance to reduce. You will still be responsible for any harm to person or property in this case.

For official support please create a support ticket using this link www.cel-robox.com/support/

ReplyQuote
Posted : 30th July 2019 10:30 am
Share:

This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.

For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.
Images and content placed on this forum may be used by CEL and in related media without reward or attribution.