I'am dealer of Control4 smart home system. In my house (it is my showroom too) I have total control of lights, comfort (nest thermostat and air conditioners), blinds, smart locks, alarm, audio, video, xbox, nas, cameras, etc. I can make all devices to interactuate each other, for example, when I arrive at home with my personal code of smart lock, it deactivate the alarm, it open the shades (close it at night), set thermostat at 24°c and starts to play my favourite list of spotify in all my flat (multi-room audio).
I have integrated the Pi Camera of the Robox and stream throughout the Control4 system, so I can watch the live streaming of the print in my TVs, Control4 In-Wall touchscreens, cellphone and tablet.
Now I would like to add some functions like receive pop-up at my phone and TVs when the print start/finish/error, etc.
The easiest way to do this (without making a specific driver for Control4) is to execute http commands to the IP of the controller and when this commands are received, execute determined events.
Could you guide me to edit the Robox/Mote files (if the can be edited) to add this commands? Obviously I am aware of warranty violation.
This community page and the content inside is publicly visible except in restricted groups. A registered community member is able to post content. Because of the open nature of this forum the content posted may not represent the views of CEL. While we do regularly read the content posted, in some cases the content may not be appropriate for the reader or may cause offence. Please help us by reporting such content. Technical advice provided in this forum may be provided with good intention and a belief that is is correct but may not be applicable to all hardware, software or user ability. In some cases content may not be relevant to newer or older revisions, conflicting or incorrect advice may be contained within conversations, community moderators will attempt to add to this or make corrections but to preserve the thread this may be on following pages or be missed as the forum evolves.
For official advice users should contact the CEL support team via www.cel-robox.com/support/ and follow the provided advice to preserve safety, warranty and function of Robox hardware or software.
This applies to any use or alteration which is not specifically described in the officially supplied guides from CEL. Community content should not be considered official even where posted by CEL employees. Only advice provided via the CEL support portal should be considered official.
Robox is a complex machine with many potential uses, to help preserve the good working order of both hardware and software please be patient and note that many common fixes for other 3D printers do not apply to Robox and may cause irreversible damage or compromise safe operation.
Images and content placed on this forum may be used by CEL and in related media without reward or attribution.